





✨ Keep your headlights shining like new — because first impressions drive everything! 🚗
E-TECH Restored Headlight Clear Coat is a 200ml aerosol lacquer designed to permanently seal and protect restored headlight lenses. Its non-yellowing, UV-resistant, and scratch-resistant formula creates a waterproof barrier that preserves clarity and extends the life of your headlights against environmental damage.




| ASIN | B0BSH52ZFM |
| Brand Name | E-TECH |
| Colour | Clear |
| Colour Code | FFFFFF |
| Container Type | Tin |
| Country of Origin | Germany |
| Coverage | 200 cm²/litre |
| Customer Reviews | 4.1 4.1 out of 5 stars (196) |
| Finish Type | Gloss |
| Included Components | painting |
| Indoor Outdoor Usage | Outdoor |
| Is Waterproof | True |
| Item Form | Aerosol |
| Item Volume | 200 Millilitres |
| Manufacturer | E-TECH |
| Paint Type | Lacquer |
| Part Number | ER00165 |
| Size | 200 ml (Pack of 1) |
| Special Features | Scratch Resistant |
| Specific Uses For Product | Exterior |
| Surface Recommendation | Plastic |
| Unit Count | 200.0 millilitre(s) |
| Water Resistance Level | Waterproof |
K**L
Works really well
This product is a little difficult to use (as all optical clear coat sprays seem to be), and so it's worth perhaps practicing with handling the spray before trying on an actual headlight. You need to get just enough to fully wet the surface of the headlight, spray steadily and consistently to try to avoid introducing air bubbles to the surface, but not spray so long that the clear coat starts to run. It takes a bit of a knack, but if you get it right, it looks near flawless.
D**E
Works well lights look much better
I restored the headlamps and they still looked hazy and milky. After applying the product, the headlamps looked like new almost. Not sure how long it will last, but the coating seems to be quite tough. Follow the instructions. As it does say allow a good 24 hours before driving thee car amd exposing the treated areas to water. The product seems to have dried hard after about 1 hour. And I will use the car tomorrow. Also worked well on the rear high level brake light which had turned pink and hazy. Now looks like new.
G**K
Useful anti-UV laquer for polycarb headlamps, with care.
I applied this after spending a lot of time buffing and polishing a UV light damaged polycarb headlamp cover, so good to find a UV protective, polycarb compatible glaze. I'm no stranger to using aerosol paint sprays, but the polished cover looked slightly better prior to using this than afterwards, perhaps owing to some overspray which I'll tackle at a later date. The instructions are clear and easy to follow, but there is scope to make a mess of it if unused to spray painting.
G**M
Worked for me.
I did lots of prep on the affected car headlights, which were very bad, using one sheet of wet and dry at 400, 800 and 1200 on each headlight, so a total of six sheets using the entire sheet each time. I also used it wet, not dry. It did not look like it was going to work as each time I washed the headlights with clean water they still looked obscured. However, as soon as I sprayed the lacquer on it transformed them and they now look almost like new, a massive improvement. The only thing I have noticed is that when it rains it leaves marks on the lenses where the water droplets have sat but they wipe off and it still looks good. Do not be impatient with how much you spray on, its not worth it. Take the extra time, keep the coats thin and let them dry before applying more. I was borderline with lacquer build up but just got away with it. I spent a lot of time doing the prep and should have been just as patient applying the lacquer.
P**E
Works brilliantly.
Worked like a charm, sanded lights with 1000, 2000 and lastly 3000 grade wet n dry. Then followed the instructions to the letter, my lights are like new!
A**N
Frosted finish
Followed the instruction carefully. Headlight was prepared correctly. Application conditions were in the middle of the parameters stated. But the finish is frosted finish and not much better than the pre-prepared / polished etc headlight cover. The first pic is the job done. The second pic is a new light. Not recomended.
A**R
Not sure about this product
Before slagging this product I just want to let you know my headlights were pretty bad. Bought this product for my 2nd vehicle whose headlights where in a bad state. They seemed to have tiny yellowy wrinkles or something like small lightning strike shapes covering most of headlight. I was hopping that the damage was just on surface layer and a DIY project might save a few quid if all goes well as compared to getting new headlights. Yeah so after some heavy sanding with grit paper from like 320 grit to 2000, cleaning dirt off with isopropyl alcohol wipes and finally using this product as final touch. I ended up with slightly fewer whiter lightning strikes but now somewhat foggy headlights. Perhaps I made a mistake somewhere in the process as this was my first time attempting this or the product is a bit underwhelming. I suggest you try on a small corner portion first to see if it works for you!
J**O
Don’t waste your time & money
Applied it less than a year ago, following the instructions. Has gone cloudy and most has flaked off. The car was under a cover for six months so not sure if that has had an effect but either way, the product is not fit for purpose in my view
T**R
ممتاز جداً شكرا على التحفه الفنيه الرائعه انا راضي جداً
Trustpilot
Hace 2 semanas
Hace 1 semana