HH-66 Toluene Free Vinyl Cement, 8 oz. can - RH Adhesives

I had an object fall off a table and put a small gouge in my vinyl flooring, I figured I only had one chance to seal it and keep it from getting worse, so I chose this glue and it seemed to work very well. This glue does shrink quite a bit, so I carefully applied it several times only in the gouge itself until it was level with the floor and I believe it will be a permanent bond

Easy to use and works perfect to install extra D rings on a SUP. Put it on, let it set up for a couple of minutes and then put the D rings on. Leave it for 24 hours and you are good to go.I tested the effectiveness by flipping my SUP on a river (the doggo gets the flip credit) and had a cooler strapped on the back to the extra D rings. The cooler stayed attached without issue.

I used it for lift bar insulation strip on hot tub. The Velcro wasn’t holding at all and it continually would fall off the cover was in pretty good shape otherwise. I dried out both sides the Velcro was attached to. I cleaned them with alcohol, let them dry well, then added HH-66 to both pieces of Velcro, let them get tacky then attached them together and pressed well for few minutes. I left the lid open for several hours (because of moisture). It’s holding beautifully!! Those new covers are really expensive, so saved myself quite a bit of $$$$.

I minus one star because I have a clear tarp after connection I can see milk glue on the clear tarp. Otherwise it is very good glue.

Worked well on vinyl fence post.

Worked perfectly to repair my paddleboard's small puncture. 2 applications needed. This brand was recommended by many. Good to only need one product and not a two-step process. Highly recommend.

So far it is holding up. It did make a mess trying to apply it. A llittle goes a long way. Squeeze out less than you think you will need.

Very strong adhesion. Follow the instructions and the glue provides a very strong bond.