HOZLYCarbide Compression Router Bit Up&Down End Mills 1/8 inch Shank with 1/8 inch Cutter for CNC Mill Machine Wookwork 3D Profile Detail Engraver Carving Pack of 10

I run a CNC based business and have tried almost every brand of endmills available. These bits are the best I've found. The value is beyond great. They leave a smooth bottom in pockets and last longer than endmills several times the cost. Normally I find that cheaper bits sometimes cut just as good as the top price bits but don't last as long, not these Hozly bits they both cut better and last and have a longer life. I buy the 6mm, 1/8th regularly and just received the 5/16th. It's hard to believe they are this good for the price but it's true. The other day I misjudged and hit a aluminum clamp with the bit and it just kept going and I let it finish the tool path and the cuts were still great!

one of the best i used

Straight and stays sharp. Good bits.

I have made only a few cuts with these bits, but the performance and accuracy of the bits was good. At this early stage, I would purchase again.

Cuts clean and with a single pass full depth 3/4” plywood, and no tabs needed, even with these smaller 2” star knobs. Ran at 18,000 rpm 55 imp on my Laguna IQ cnc with 3hp spindle. Not sure how long they’ll stay sharp, but at the price, these are definitely a great value and work great for my purposes.

I saw these bits on YouTube cutting 3/4" plywood in one pass. So I had to get these to try out. Sure enough, I now cut 3/4" in one pass with my Avid CNC. Haven't had any to break so far, but if they did, they are cheap enough to just replace.

Great product.

This bit has preformed exceptionally. Has cut my carving time in half. The reason for the low rating? It isn't 6mm like advertised. Mine measured at 5.89mm, which ment I had to seriously sinch down on my 6mm collet to secure it. So far it's held up, I just worry that it'll come loose.

La relación costo calidad es buena, falta probar la durabilidad

they are tiny and short. near useless to me. maybe if you have one of those 99.00 cnc's with a dremel. these'll sink to the bottom of my bits drawer.

The price is outstanding. The quality is outstanding. I can cut 1/2" plywood in a single pass, on my CNC. The bits stay sharp for a really long time. The only thing bad is they don't like cutting through knots in pine. They'll get stuck, if you're unlucky, and snap. Fortunately, you get 5 in a pack.

Alta qualità

These were recommended by a fellow youtuber and I have to say they really are great value