SpecificationsCondition: 100% new Color: Grey & Black Material: Plastic & Metal External Size: approx.5.4cm x 3 x 5.5cm (2.1 x 1.2 x 2.2inch) (L x W x H) Terminal: 4 Pin Voltage: 250V Rated Current: 18(16) A Rated Frequency: 50/60Hz Degree of Protection: IP55 Number of Operating cycles: 5E4 Item included: 1 x 4Pin 2BTN Switch Suitable for: Using on many workshop machines. Note: 1) All dimensions are measured by hand, there may be small deviations. 2) Color may vary slightly different due to the color setting of each individual monitor.DescriptionFeature:1) Rated at 16amp, it will be suitable for induction motors up to 1.5hp or brush motors up to 2hp. 2) Simply connect using insulated spade terminals, the connections being clearly marked for input and output. 3) It is a no volt release type of switch, providing safety in the event of an interruption of power.
J**N
Fits the Bill
This magnetic contactor switch replaced my factory installed mag switch on my dual voltage motor driven table saw. I changed the motor wiring to run off of 240VAC rather than 120VAC, replaced the lower rated starter switch with this product, and replaced the cable end to fit my newly installed 240VAC service outlet. Fits and works perfectly fine for my application.
R**H
This was the least expensive price for this item type ...
This was the least expensive price for this item type. it worked as advertised. The shipping was slow but worth the wait.
A**R
On time
Wrong part. Reorder right part
A**G
日本では100Vタイプを確認して買いましょう。
同じ型で250Vと100Vのタイプがあり、形だけ見て購入して交換したら動作せず！ボタンを手で押してる間だけ動作した。よく見たら250Vタイプ！再度100Vタイプを購入交換し修理完了。
Trustpilot
Hace 1 día
Hace 2 semanas
