Rust Converter Aerosol 400ml

Excellent product, easy to use and works quickly. I was previously sanding off rust by hand prior to painting and this has saved me a vast amount of time. I will. E buying it again!

This Jenolite Rust Converter Spray is really good. I was surprised how fast this spray worked on my rusty Ford Fusion underneath. You don't really have to paint any underseal paint on top of it, but i always make my special mix of paints and black gasket sealant mixed up with some paint thinners, works a treat everytime. I strongly suggest you wear protective glasses, face mask, gloves and some old clothes before you start painting. Try to remove all the bad rust, either with a good wire brush or one that fits to a drill or grinder. Remove all grease and dirt before spraying the Converter Spray. This isn't cheap stuff but it does the job on any rusted item's. Rust is just like a 'Cancer' it spreads if untreated. Always look after your vehicles and they will last for years. I highly recommend this "JENOLITE RUST CONVERTER", Just a shame it's so expensive..

Good quality spray. Can make metal go black on contact.

After a bit of research into what product was best for my needs, I opted for Jenolite Rust Converter Spray. Stone chips had broken through the paint around the arch areas of my campervan, looking unsightly. A quick rub down on the affected area with 80 grit oxide paper back to clean metal, masking tape applied to avoid any overspray, then follow the instructions on the can - shake contents for a few mins, then apply from around 25cms, leave to dry circa 15 mins, then re-apply. It's clear initially, but as it gets to work it turns black, after 2 coats a thick protective layer is formed, after fully dry / cured the epoxy feels tough and has good coverage, I'm letting it fully harden over this week, and will look to apply a top coat of colour matched spray paint, and clear lacquer top coat to blend it in, and will then apply 2 coats of the Jenolite on top of the colour matched spray paint for added protective layer as it is clear. Good product, good performance straight out the tin with minimal prep, instructions are simple to follow.

Easy to apply. Fast drying and works well. Great coverage per can. For reference I did two coats on all rear suspension and rear floor pan of a vw Tiguan with 2 1/2 cans

This is a great product. I recently used it to treat the underbody of my 20 year old Ford Focus. It provided excellent coverage, and a good surface for paint to adhere to. However, as always with any type of paint/protector product, the preparation is every bit as important as the product itself. First, use a wire wheel and/or sandpaper to remove all the loose rust and dirt. Then use brake cleaner and a cloth to thoroughly clean and dry the area, and remove any grease. Only then should you apply the rust converter spray. Under these conditions, the spray adheres well to the surface, and forms an impenetrable epoxy barrier which stops rust developing further. Once this is dry, you can then paint it with the colour of your choice.

Good product , delivered quickly . Time will tell if the rust is contained . Used this product in my youth and it worked well then .

Very easy and clean to apply. Scrape and wire brush off loose rust. Apply 3 coats, leaving 15 minutes between each coat. You can see the remaining rust turn black as you apply.

Follow the directions carefully. Spray OUTSIDE. Prepare to leave whatever you're spraying OUTSIDE for a minimum of 2 days with any sprayed areas OPEN. The fumes will go away, but they are very strong. The warnings on the can make this very clear. I used it to spray rust in the spare tire well in the trunk of my car which didn't rust due to water intrusion ... nooooo - it was mice that made their home in there. Their 'biological leavings' ate through the paint and caused rust. Also applied to other various areas that made light surface rust after sanding in the process of repainting a car. Coats really nicely, had no problem putting an epoxy primer over the top of this stuff (I gave it a week). Worked exactly as advertised. The more work you put into preparing the surface, the better the product will work.

Schnelle lieferung, EXTRA gute qualität !

High quality rust converter spray. Nedded fir car body repairs and where you need to fight with rust. Clean the place of rust, spray it and wait to dry about 20 min. and paint. The job is done very simple.

le meilleur stabilisateur / convertisseur de rouille que j'ai utilisé, traite et permet de peindre rapidement. super produit

Rispetto ad altri convertiruggine fornisce un feedback non troppo evidente, la ruggine resta un pò più rossa rispetto ad altri prodotto. Crea un film che è praticamente trasparente, ma funziona. In versione spray è perfetto per raggiungere punti difficili