RATTMMOTOR DC Brushless Spindle Motor Kit, 500W 48V Spindle Motor Air Cooled ER11, 12000RPM, 0.6N.m, 55MM+BLDC Driver Motor Speed Controller 600W Spindle Power Supply+Clamp Mount for CNC Router

Added this to my 1318 mill, works great and easily is integrated either MakerBase board via a $7 PWM to 0-10v board. Very low runout. And has the power to drive 1/4" bits through wood or 1/8" through light metals easily.

I received the new spindle assembly on 11-14-24. It looked basically ok, but the end cap on the motor looked slightly crooked to me, so I verified that it was angled by several degrees and then removed the end cap to inspect it.I found that the barrel outer casing of the motor had an edge that had been peened around the entire diameter. Possibly from beind dropped during manufacture. The end cap is intended to slip over this lip, so that a machined surface inside of the end cap would rest on the barrel of the motor. This it could not do. Instead, the end cap rested on this peened surface, and just ended up where it ended up. This end cap centers the motor shaft bearing, so the cocked end cap also cocked the bearing. I hand filed the protruding edge on the barrel so that the end cap could slip over it and seat properly. This allowed the bearing to seat properly.Once reassembled, I verified that the end cap mounting was true and found tbat the motor shaft now turned much more easily.I noted that the inside of the end cap had multiple raised casting burs that were sharp and were in close proximity to the tops of the motor coil windings. These burs were turned down on a lathe for safety.After reassembly, I connected the ESC and power supply, and they worked perfectly. Although not prewired, I tested the reverse function on the ESC, and it also worked perfectly.I am rating this product 4 out of 5 because the design is good and it met my needs, *but* the manufacturing flaws were hard to ignore. If you do not have the skills to deal with this sort of thing, then I recommend that you purchase a more expensive unit elsewhere that has been vetted.

This is much quieter that my 775 spindle that came with my cnc.

Motor is smooth, lots of power, runout is as advertised at .0005" measured from the ER taper.

Great motor, runout is excellent. Including this photo in case anyone finds it helpful.It's important to note: there are no instructions in the box, no fully wired photos on the listing, no step by step guide or even color coded labels to connect the components together. Although the seller has published detailed specifications, the reviews actually contain more useful instructions in terms of assembly.This kit should probably include a solid state relay to more easily upgrade an existing machine and not have to worry about the spindle running infinitely after a job completes.

It was a great price and was easy install. The only thing is I'm not sure of the actual spindle speed it seems slower. It's super quite and that's a big plus. Will update a few months in.

Everything worked well until 2 days after the 90 day warranty expired the power supply quit. The spindle motor was quite with very low noise. You would think the power supply would have overload or fused protection.

Seems good so far and runs at low speeds pretty well, quiet and strong. One warning, the power supply has a 110v/220v switch on the side, mine was set at 220v, the motor still ran but was lower rpm, after switching to 110v, I seem to get full speed