Key Fob Keyless Entry Remote fits Toyota Camry Sienna Matrix Corolla Solara/Pontiac Vibe (GQ43VT14T w/Panic), Set of 2

I have an 2003 & and a 2006 Pontiac vibe. I bought these over a year and a half ago. Followed instructions and work perfectly. I just had to switch one to the other car, so I looked up my purchase to get the programming instructions and decided to leave a review. They work just like the original. I just lock and unlock..I've never tested the hatch or panic button but I'm sure they work. I would order again if I needed them.

Great product easy programming!!

Worked just like OEM. I was able to program them very easily and have had no problems

Nice, wasn't easy to connect but works for the price

Doesn't program, therefore useless.

Worked great, easy fob programming.

Excelente calidad 👌🏻

After much frustration, I found that the key (pun intended) to doing this right is to pull the key out IMMEDIATELY after pushing it all the way in. NO HESITATION. Also, it comes with a battery, but you might have to change it like I did. The instructions to "Perform these steps within 5 (or 40) seconds" can be distracting for ADD types like me. I would just ignore those or even delete them. If you do the steps quickly one after the other the whole thing takes less than a minute, anyway.To save everyone the trouble, here are the exact instructions from their website. GOOD LUCK!1. Start with the key out of the ignition, drivers door is open all others closed and drivers door is unlocked.2. Perform these steps within 5 seconds.A. Insert the key into the ignition(Do NOT Turn) Pull key out.B. Insert the key into the ignition(Do NOT Turn) Pull key out.3. Perform these steps within 40 seconds.A. Close then open the drivers door.B. Close then open the drivers door.C. Insert the key into the ignition(Do NOT Turn) Pull key out.4. Perform these steps within 40 seconds.A. Close then open the drivers door.B. Close then open the drivers door.C. Insert the key into ignition and leave it in ignition.D. Close the drivers door.E. Turn the ignition to ON (Do NOT Start) then back to OFF.F. Remove the key from the ignition.5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode.Return to step 1 if the locks do not cycle at this point.6. Perform these steps within 40 seconds.A. Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.B. Immediately after letting go of the lock and unlock buttons,Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted.C. Repeat steps A and B in step 6 for each new remote.7. Open drivers door.