Ryanstar Throttle Cable Bracket 4150 4160 Series throttle brackets Billet Adjustable Aluminum Black

Fits fine on my Holley Super Sniper Stealth without interference. Only problem in this specific application is there isn't any place to attach both springs to on the EFI unit itself. No fault of the bracket or design and one spring will work. Finish is nice, clean, and it comes complete with eveything for GM styled cables or Morse styled cables. Great value and well packaged. Happy I found this compared to more expensive options.

Super great quality throttle bracket works great and fit great love it

Excellent Product

It is nicely made, and was cheap. I got it for an 800cfm edelbrock avs2. It doesn't fit. The end of the throttle shaft hits it, where it was riveted to secure the throttle arm to the shaft. The interference it about 0.120". I think I'll keep it, maybe machine away 0.125" to make clearance. Not sure yet. It isn't that wide there, and removing 1/8" will reduce it's strength significantly. Another option is to bend it. I'd do it with wood blocks carefully in a press. The mounting holes will then be too close together, and the cable and spring angles will need to be corrected. I'll see..it is cheap enough to keep. It probably fits fine on a Holley, maybe I'll use it for that. But..just so you know- not a bolt on for an 800cfm AVS2.

Works with my aces efi system and looks good! Easy install

This little contraption is such a simple and elegant solution to a lot of really annoying problems you’ll run into when trying to properly set up a Holley carb on your engine. If you have a Mopar and are trying to figure out a kickdown setup that actually works, this is it. It doesn’t matter if you’re running a high rise intake, factory setup, whatever. It just works and doesn’t rely on maintaining factory geometry or linkage. Pro tip: the kit ships with two brackets, one for throttle, one for kickdown. One is really thick, and one is thinner. The thin one is mounted as the default throttle cable bracket. If you run into the issue I did where your kickdown cable is just barely too short, use the thin throttle cable bracket for the kickdown and use the thick one for the throttle. They are fully interchangeable and there’s no wrong way to mount them. Once I did this and mounted the thin bracket with my kickdown cable all the way forwards towards the linkage, it all fit together beautifully. The fact that this is only 20 bucks is really cool. The Holley one that this is a 1:1 copy of is almost $100 and is still worth it even then because of the sheer number of headaches it nullifies and problems it makes go away. This is a no brainer purchase if you’re needing linkage and are running a Holley carb.

Spring tension too strong even with adjustment. I had to use my older springs and bracket at an alternate location.

Great quality, great price

Cumple su funcion

Very impressed with the quality. Well built and fit perfectly on my 750 Holley carb and looks great

works well with my 750 street demon carb, better trottle response

Very good Gaz cable bracket ,like the professionel use , fast shipping and best price!!

I have a demon 4 barrel carb I has to take about half the material off the center portion to allow the throttle lever to function and to mount the bracket. Still love the product for the price and like the purchase. May want to see if you can extent the center portion out 1/2"