Leviton 42777-2WB Surface Mount Backbox, Dual Gang, White, 1.45 Inches

Unfortunately, 2 of them cracked during basic install. It was challenging to get box to not warp when installed. Should make thicker.

This box is small and makes for a very tight fit of the cables. I can be mounted on the outside of a surface. All the screw holes fit well.

I used this outlet box to install a set of outlets onto the front of a control enclosure.Since that's not exactly what these boxes were designed for, I'd say that it did the job just fine, and is a testament to the versatility of these backboxes.There are knockouts all over this thing for finding ways to get your wires into it. All four sides have multiple punch-out options, and the back also has three punchouts.Speaking of the back panel, you have countless mounting options and screw holes for attaching the box to your wall, enclosure, or other place of electrical interest.While running your wires, remember that this is a nonmetallic enclosure, and you will need to make sure you have ground available on both outlets. It's not going to do it for you.The only knock I can give this box is that because of its low profile design, you don't have a whole lot of room to work inside and run your wires, especially for heavier 12ga installations.Installing a GFCI and a USB charger outlet left me with very little space to run the wiring, and it felt cramped, but that's the price to pay for putting that much outlet into a box this small.

Easy to install over an existing outlet. I used this 2 gang to install a deep dimmer switch that wouldn't fit in the old metal 1 gang box. This attaches to the old box with use of the provided screws into the old switch mount holes. I centered it for looks, but it slides when pushed hard, but that's not biggy. The back plate attaches first, after you have cut out the back slot to allow your wires through. Once it's mounted you press on the box, do your wiring, attach the new deep switch...botta bing, your now ready to install the faceplate. This 2 gang box is very versatile. I highly recommend it if you need to install a deep dimmer, and have no room to do so. I went with the 2 gang, because it was thinner than the single gang, but would still allow installation of the switch. Plus it is more appealing to the eye, over a bigger single gang box.

The surface mount low profile boxes were exactly what I needed to add a couple of garage door switches. Just moved into a new house and it had some super old goofy looking pushbutton actuators for the garage doors. I bought some Leviton contacts switches that look very similar to pedal switches and they fit perfectly inside of the surface mount box. I was hoping it came with the front plate but that’s OK I will order one I think they’re only a dollar or two. You may want to measure to make sure that your switch will fit as only certain sensors will fit and certainly no Wi-Fi enabled switches will fit. I preferred this box because I didn’t want a deep box sticking out of my wall - this 1.25inch depth is perfect compromise.

This was a little too shallow for my dimmer switch. There are gang box extender rings you can but, but they're as much as this box. For regular outlets and switches, this would be just perfect. Nice and sturdy.

This is not a good product. Cheap quality at a high price.

Needed a white, surface outlet box. This box fit the bill. Clean design.

Wrong dimensions and too shallow to mount.

good

Très solide comme boite mais un peux gros

Was perfect for my project..!

Perfect