NewYall Pair Front Left and Right ABS Wheel Speed Sensor with Harness and Dust Shield for Chevrolet Blazer 1995-1997, S10 1995-2003, S10 Blazer 1991-1994, GMC Jimmy 1991-1997, Sonoma 1995-2003

Exact fit for a 2000 Chevy S10 or Blazer, bit of a process to remove estimated work time 1 hr with the right tools, and when I say right tools,examples: Jack, lug wrench, 1/2 socket, 7/16 socket, sometimes you need a 10mm socket and hammer for small bolts that may have some decay, trust me a must, 1/2 wrench open end wrench, new cotter pin, channel lock pliers, medium head flat head screwdriver, high temperature grease, needle nose pliers for cotter pin, PB Penetrator for stubborn bolts, and the most important tool 3/8 allan wrench for brake caliper. It is very easy to install, if you are used to general automotive maintenance. If you are not recommended for a mechanic.

2001 s10

Perfect fit for my 1999 chevrolet s10 2.2 liter 5 speed 2 wheel drive rear wheel drive half extended cab short bed pick up truck. Had no issues. Thanks a bunch.

The backing plate has a different bolt pattern than the original.

Great product. Easy installation

I am fixing up a Chevy S-10 Xtreme pickup truck. These front backing plates (dust shields) fit very nice and look great. Two Thumbs Up! Thanks Amazon

Backing plate which holds the sensor is NOT the exact fit as OEM. One of the bolt hold downs (very top) there is a half inch gap. This is goes for both plates. This misalignment causes the sensor not to line up with the reluctor ring on your rotor. I would recommend removing the sensor and its wire (requires prying the cord out from the metal tabs) from the new backing plate and toss it into the garbage. Reuse your old backing plate and attach the new sensor. If you don't want to go through these extra steps/modifications, I would recommend you purchase another brand. More than likely (though), you'll get the same Chinese junk. Genuine GM is probably your best bet.

Fit great, I got some I believe M8x1.25x15mm bolts from the hardware store to bolt it down to the spindle, great fit and new ABS sensor.