🎶 Amplify Your Audio Adventure!
The HiLetgo 5pcs LM386 Mono Audio Amplifier Module is a compact and powerful audio solution, featuring a 200 times amplification capability, adjustable control, and a versatile operating voltage of 5V to 12V. Perfect for DIY audio projects, this module is designed for easy integration and superior sound quality.
Number of Channels | 1 |
Package Type | Bulk |
Output Power | 2E+2 Milliwatts |
Mounting Type | Surface Mount |
Voltage | 12 Volts |
A**A
Easier Than Building My Own
I teach junior high science, and in one of my lessons, I connected an LED to the audio output of my laptop so students could observe that the current changes directions inside a speaker. (LEDs have positive and negative terminals, so they only light up when the current is connected in the correct direction. So regular LEDs flicker on and off as the current changes, and two-color LEDs change colors). But the directions provided in the curriculum didn't work. Upon further reflection, LEDs require more current than my computer's audio output provides, so I needed an amplifier. But the amplifier sent with the curriculum didn't work either.So I brushed off my electronics skills and began preparing to build an amplifier using my capacitors, resistors, etc. One of the components I was lacking was the LM386 audio amplifier (which is one component of this piece of hardware). But this device was less expensive than buying all the missing components and building my own amplifier. Plus, you get 5 of them. I connected this amplifier to my LED and the experiment worked. (I had to bend the input pins so that the alligator clips from my audio-to-alligator-cable clips and wires from the battery could all connect, but there are circuit diagrams for this device easily found online).The sound quality wasn't great, but it would probably be better if this device were used as intended, soldered into a larger electronic device, rather than connected to other components using a breadboard. Also, the low-quality speaker I attached in parallel with the LED might have been part of the problem.
A**R
Great Little Amplifier (with a hint)
This is a great little amplifier for anyplace you need to boost signal levels. One helpful hint: If the gain of 200 is too high (and it usually is for me) just remove C1 to drop the gain to 20.
M**E
Pretty good little amps
They are pretty good but at higher volume distorted. Will not run a 16 ohm speaker.They would be useless for playing at a rock concert unless you ask the audience to be very quiet and supply hearing aids.That being said I did make a mini guitar amp and the distortion is quite good.
V**T
Great little amp.
Worked great. Used them to make a small guitar amp out of an old speaker. Added an input jack and ran it off a 9v battery. Sounds great at desktop volumes. Can even get a little breakup/distortion when cranked.
A**N
Nice little amplifier for various projects
Easy to connect and it works
J**.
Small and powerful
Great amplification with a homemade am radio. Volume pot a little iffy. Still very happy
S**R
Don't get
Absolutely terrible. I went against my gut to believe the previous reviews and I was dead wrong. These barely worked. I'm better off going to buy a $10 bluetooth speaker at dollar store to take it's board out.
H**Y
Very noisy
The sound/signal coming from these are very dirty.
Trustpilot
Hace 1 mes
Hace 4 días