BETAFPV Beta75X V2 3S Brushless Frame Kit Black with 2 Sets 40mm 4-Blade Props 1.5mm Shaft Blue for F4 AIO 12A FC 110x Series Motors 75mm Whoop Drone Like Beta75X HD Digital VTX

I had to replace the frame on my Meteor75 since the original one broke after much abuse. This one worked out fine, except it did not come with a battery pad (I had to fashion my own) and the plastic loops for the battery itself broke within minutes of my first flight One or two drops on to my patio was all it took. I wouldn't complain, but the original frame had been through significantly worse. So far glue and tape are holding it together.

I guess if you were a good pilot and you didn't crash a lot it'll probably be a good frame for you!!! The flight characteristics of this frame was amazing but the durability was not there!!! Probably be a good frame for a very experienced pilot but I just crashed too much for it!!!

I have a lot of the small quad copters and have never had a problem breaking the frame while I was installing the flight controller.

I've been flying a 75X for a few years. The original frame was much more durable. They took a step backwards with the V2 frame.

Fragile handle with care

Nice little lightweight 75mm frame that fits both the triangle shaped motor mount for 0802/ 0803 motors and also the square motor mounts that fits 1103 / 1106 motors. I'm using the Betafpv 2S 1103 11000kv motors that have the square mount with this setup, Gemfan 1636 4 blade props, GNB 350mAh 2S Li-HV (pretty snug fit in the battery compartment), HGLRC Zeus5 AIO FC, Radiomaster R81 Frsky external receiver, Zeus 350mw VTX, Runcam nano 4 FPV cam, a single WS2812 LED, part of a package of betafpv silicone FC rubber mounts and screws, I didn't use a capacitor because they're pretty heavy on a 2S whoop, and after everything this is a lightweight, powerful, and durable 2S whoop. This is the lightest 75mm frame I have right now and it even has a slot to mount an LED strip, holes to feed antennas through, just enough room for a micro receiver to fit on the bottom side of the FC (the battery compartment is raised up higher now than the old version of this frame and an RX still fits!), and it's been great. I saved the 8 included 40mm blue propellers for extras (I wanted a red/black combo) but I'm pretty sure they're the same as the 1636 4 blade props I'm using, which are for a 1.5mm motor shaft size, and if they're not exactly the same - they're very similar. Great little lightweight brushless 75mm whoop frame that will give you plenty of options.