Dantawood Tabletop Wood Printer Stand, Multipurpose Storage Shelf for Home, Office, Printer Desk, Home Printer Stand with 4 Cushion 2 Tier Small Printer Stand (Brown)

Definete buy, Quality is amazing. Price can be little lesser

Good and strong durable product.. quality is good. Value for money.

Good one

Great quality product. However, my HP 419 printer was bigger than the space here. It may not be suitable for any HJP printers, I think. Also, the ground elevation is quite low. Should have been at least an inch.

Sturdy quality. But price should reduce to 600 to 700

Product is of good quality and saves valuable space on your table/kitchen shelf.I purchased it primarily to fit my HP 1020 plus printer (more on this later) and other accessories on the my table.The metal frame is very study and quite heavy. You can trust it to bear good amount of weight. Paint finish is good. Slight finishing issues can be noticed but you will forget it once its there on the table.The ply is probably particle board with a good finish and should hold its own in the long run. I won't recommend using it in the kitchen though, since moisture may seep in the long run and damage the ply.I did not carefully see the images of the product and the dimensions. Hence my HP 1020 printer did not fit inside this stand. My printer at home (1108) easily slipped into the stand and hence I shifted the stand from my office desk to my home desk. So in case you are planning to fit in your printer, carefully read the inner dimensions of the product.The stand is durable and VFM product. Price is reasonable given the good quality of metal frame used.Recommended 👍🏽

Nice

I’m happy with the purchase. Looking good and no quality issue.

I’ve been looking for something like this to stack my laser printer and my Cricut. It’s perfect.Assembly was mostly easy. The bolts and included Allen wrench don’t fit perfect, but that’s a minor point. Assembled and ready in about ten minutes. No complaints!

I sued this for my laser printer, and the top shell to hold a file folder stand, so it does save counter space ! The papers feed out flat, so the few inches above the printer are fine. I would like the bast to be about 14 inches deep for full support of the printer base, but it does work fine for what I was needing :)

Ich rate vom Kauf ab.1. Der mitgelieferte Imbusschlüssel passt nicht.Und:2. Egal wie rum man versucht, die Bretter an die Ständer mit den gelieferten Schrauben zu schrauben, auf einer Seite sind die Gewindelöcher um ca. 0,5cm versetzt, so dass ich dann am Ende für 2 Löcher Spaxschrauben nehmen musste. Was für ein Crap!Genauigkeit beim Messen und Bohren Fehlanzeige.

Not able to get a printer on the bottom shelf...definitely a photoshop attempt to fit something there when it would fit and overhang on the top shelf only and have only room for 3 or 4 reams of paper underneath on the bottom shelf.

It does exactly what it is meant to do. In my case, we have 2 printers & have kept the lighter one top. Works well. There can be some dimensional changes but this is fine too.