GM245 Fuel Injector Seals Tools Set Perfectly Compatible with GM Subaru Engines, Replaces for #EN-49245, EN-51105 and #18683AA000

Worked good took a little patience but once did 2 the rest came easy. Used it to do all the seals on an lt4 gm engine

Will work for 2016-2019 chevy cruze, and malibu that have the same 1.4l engine. Kit worked well, only thing I have to say is the seal pusher, is plastic, and i had to pinch the tool right before the o-ring/rubber band to prevent it from slipping over the seal when trying to set it.Other than that, no complaints.

Junk. Messed up the first set of seals. Managed to get a new set and compress them with it but the tool used to slide the seal up the cone was junk too and had to use my fingers. Ended up getting a bank 2 fuel trim lean fault code after doing a DOD delete. Just replaced the seals again. Pulled injectors and two seals were completely torn. Both on #6. Bought the Lisle 34720 part number instead. Way way way better and compresses the seals smoothly with nice instructions.

great tool to use to install injector seals fo gdi engines. its a must have tool. its easy to use and it helps the seal fit pefect in its place. it prevents leaks and seal tear when installing the injectors. great tool.

One set of installers, a short and long, fit well over the GM 5.3L injectors. Long adapter installer for the upper seals and the shorter for the lowers. Using the pusher is optional. I put half mine on without using the pusher. Once I remembered that’s what it was I slipped right over the seal. It needs to be held firm to push the seals along the installer.My issue is with the sizer. I couldn’t get past the lower seal to size the upper seal. I tried everything. I let all seals rest a minute after installing. Used my fingers to begin sizing them in. You have to work the sizer around the lower seal, pressing the seal all around with the tool and even then, there’s no getting past the lower to do the upper without pushing the lower out of place. I worked the sizer for quite awhile and was never able to get both of the sized. I ended up using my fingers to press the seals into place and left them overnight hoping the cold garage will promote shrinkage and contraction enough to install the injectors today. I’m weary about how the day will go. If I will know whether the seals stayed in place or not after going down in the hole into position. If there’s an issue, I surely update.

So far so good 👍

Dosent work that well. Took awhile to figure out how to work it

So I replaced injector seals on 5.3 GM V8. I was working with aftermarket seals the first go round and they were horrible. The tool kinda did the job. But when I got got genuine GM/AC Delco seals the tool work like the Kentmoore tool does. I would say the tool is a win if you don’t have $250 for the kentmoore tool just make sure you are use genuine parts.