660V 30A Single Phase 2 Inlet 12 Outlet Metering Box Junction Power Distribution Terminal Block (2 Inlet 12 Outlet)

very good for my model railroad

The two big screws can take decent-sized crimp-on lugs, but the rest of the connections have 2 screw down connections, which would normally be fine, but i noticed soon after I had connected the first piece of equipment, the cable looked a bit loose.As i touched it, it sparked!I disconnected the cables and the red cable in the picture pretty much fell out of the hole, even though I had made sure it had been attached securely.See attached picture.You can see the red cable has a sort of semi-circle cut out of the end, and hardly any strands still attached, and the black cable only has about half of the original copper strands still attached.I think when tightening the screws, they actually cut through the copper strands!I stripped a new section and screwed them back in. Hopefully it won't happen again :/Be careful!

i am putting solar panels and batteries in to power the shed and got this to to bring all the wires together then connect the inverter to itabsolutley brilliant

Looks pretty good I think it is a good product.

easy to use dose the job

The media could not be loaded. I used this item for my electric project on my 12 foot boat,, it makes my connections easy ,, I recommend this item

バッテリーからの仮組で配線の太さや、圧着を形に合わせてしなくてよいのは便利です。穴に入れる配線の太さが足りないものは、剥き出しで上部のネジに巻き付ければ仮組としても十分利用出来ます。必要になれば、リピ買いすると思います

Needed terminal connects for all my graphs and transducers. Works perfect. Remember to tighten all screws not used. They come loose.

I use this with a power supply to build a circuit for security cameras. My only complaints are that the holes for output wires are too wide for the screw that holds the wire in. I had to double the wire ends over and twist them to keep them from falling out. The other complaint is that the screws that hold the plastic cover on are a nuisance. It could have been better designed to have the cover snap on vs two screws that you have to keep up with and are an extra step when making "quick" adjustments.

Used this in a junction box for the solar panels on the roof of my RV.OMG! It's PERFECT for that! Use it with 1 or 6 panels. I have 3 panels now, but can easily add more when I'm ready.