Black Gloss 3ft x 5ft Car Wrap Vinyl Roll with Air Release 3MIL-VViViD8

I recently purchased VViViD Gloss Black Vinyl Wrap Adhesive Film and am thrilled with the performance, ease of use, Highly recommended for anyone who is looking for a reliable product with great quality.

Wrap looks good, responds to heat pretty good, kind of hard to stretch due to how thick it is but manageable. I used it for interior trim pieces, if i was to do it again i’d look for a thinner stretchier wrap just because its a pretty thick film but for 10 bucks you get good value for money, although its already impossible to keep clean in the interior since its so glossy

Easy install. Warm up to stretch and fit curves or edges. High gloss finish and holds up well. Thought I had damaged when installing until I realized it had a protective film on top. Easy to squeegee out air bubbles.

I wrapped a chrome bumper and a grill on my Silverado LTZ Z71. Vinyl came undamaged and got here quickly. Any minor creases came out with a little heat. Had some minor scratches which were easy to see as I got black. Wish I got a smaller sample as it's slightly more gray than my gloss black truck when viewed in full sunlight. See pics. Last pic is a before pic. I've worked with vinyl a few times, but not a pro. I found this vinyl pretty easy to work with on flatter surfaces It felt pretty thin and heated quickly. Too much pressure or heat and it tore pretty easily when conforming it. And I noticed it did not recover as well from stretching as some other vinyl I've used and it starts to lose color if stretched too much. If overworked or you have sweaty hands it starts to lose adhesion. It scratches VERY easily. I wrapped my felt applicator tool in an eyeglasses cleaning cloth to minimize scratches. The felt was leaving lots of scratches. Easy to see since I used black. Measure your item and add up to 10 inches in each direction you have enough to pull on. Watch some videos of it's your first time. If your wrapping a car I reccomend washing it, clay baring, then remove the part of possible and wrap it in a clean and warm room away from pet hair or dust.

Great value very good quality looks great we made decals with it for almy. Husbands truck it was easy to use and didn't fade the color easy to get bubbles and creases out last a long time so is very durable

Pro- easy to use and Black is deep and glossy Con- because it's easy to use for repositioning, you lose the aggressive tack needed on contours. This vinyl would contour but then begin to bubble back up in the contoured areas. Once it's in the sun it will bubble up even more in those areas. you can press them back down most of the time, pin prick the air out for some but all end up returning within minutes because the tack just does not hold. Conclusion - I was wrapping fender flares for my suburban. I have been cutting vinyl for over 10 years and have tried many brands but this was reviewed as the best black gloss so I tried it. For my project it was a WASTE of time and money. I applied it to the driver side flares only and now may remove and strip them so I can have them painted instead. If that's the case then I do have half the vinyl still unused. I may use it on my hood because its flat or just attempt a return. I have honestly never seen vinyl lose its hold like that, especially within a minute of being applied and pressed. Even tried some heat and aggressive pressure but nothing helped. So if its flat and basic, go for it! Otherwise buy a premium brand!!!

I was pretty pleased with the wrap of my door pillars. It was my first time and any original mistakes during installation were my faulty (imprecise cuts). I overworked some places trying to get the wrap deeper into a crease in the pillar and ended up with surface marks, but again, my fault. However, a couple days later, after being parked in the sun for a few hours, a 1/2” bubble appeared. Once the wrap cooled, it deflated, but left a very noticeable mark from where the outer bubble edge didn’t quite deflate. Tried to rub it out and apply heat to “self-heal”, but no luck. I’ll live with it, cuz I don’t feel like redoing it. It’s a Porsche, so I should prob care more, but I don’t lol. If I do redo the pillars later, I’ll try a different brand. Someone suggested Avery in these comments.

I don't even understand how this stuff is so durable. I wrapped my mountain bike almost a year and a half ago and it's been through 2000+ miles, hot sunny days, mud, rain, and snow. The vinyl is still adhering like the day I applied it and the color doesn't appear to have faded in any way. This stuff holds up better than paint my mind is utterly blown lol. Vinyl over a year old in the pic Must mention I found installation very easy with no bubbles and very little squeegee. Apply from the middle and spread outwards!

Great product ! The finish is great . Not the easiest wrap I have worked with but it’s ok looking .

Average product

I like it, for my car bumper protection.

Unfortunately arrived with alot of bubbles from the cap which has marked the vinyl itself and squashed I may be able to salvage some.

5ft roll in a 4 ft box, ya both end a scrap