Front Inner Splash Guards Fender Liners for 2007-2019 Jeep Wrangler JK JKU 4WD Bolt-on Style Aluminum Flare Wheel Well Cover

First off, they could have included a couple self-tappers to complete the install and deleted the mystery round plate that does absolutely nothing(wtf?). It fits pretty well and might require a little bending which is pretty easy to do by hand. I honestly expected to have to grind some edges to avoid rubbing, but didn’t have to. Looks great when installed and fits pretty good. I picked these because they didn’t have a cheesy design which is apparently hard to find on Amazon. Definitely could have used some washer for the tiny bolts. They included so many extra nuts that I used those as “washers” to prevent the bolts from pushing through. You’ll need a few self tappers and some washers to complete install.

I got these because the price point and material finally hit the right spot. The reviews were also really helpful so I knew what to expect. Because the price was low, I also picked up a rivet nut tool at harbor freight for this project and what turned out to be an other $40 of rivet nuts and m-5 screws because my wife wanted black hardware. I am satisfied with the product. But, on my 2008 Jeep Rubicon unlimited the produce is about 1/4 inch too short on the top/front corners. The gap is hardly noticeable, but I know it's there. Also on the drivers side, lower corner the cover seems like it needs another attachment point, but it's too short and there isn't enough metal on the body lip. If tapped the cover rattles on the body/frame, I did not hear it on the road though. I will probably just cut a little extension tab so that I can screw it down.Installation was not "easy." It required a little bit of skill as well as the right type of drill bits for the install. Make sure you have the right sizes and type. The aluminum product is easy to drill, gut the jeep, namely the radiator mount needs something harder than the easy to find "titanium." (I will be looking for a set of cobalt bits for this type of project." A helper would have been nice but I was able to finish the project in about 3 hours. I had to drill some extra holes in different locations due to previous modifications I had made.I will update this for long term after we run some trails too.

Leave the union snug so adjustments can be made, they fit perfectly. Literally took 10 min each wheel.

Meh fitment isn't great had to re bend both sides the bolts that come with it are too small for the holes drilled in them for alignment . See how long they last before a tire deletes them main fitment issue is on back half to firewall to frame. Front half fits nicely and looks great.

Absolute TRASH!!!! Showed up damaged. It also fits like garbage. If you are handy you’ll make them work. I would rate a 0 but that’s not an option. Get what you pay for folks. Hopefully this review helps you decide to buy a nice set.

Drivers side installed in about 10 minutes the passenger took a little longer as I had to reroute my winch wires. Also the passenger side needed a little persuasion with a dead blow at the front. Was a body man by trade for 20 years and I’m used to things not being perfect. I think any complaints are from people that don’t understand that jeeps are mass produced and so are these inner fender wells by a different company. I would not hesitate to buy these again especially if you don’t want the silly designs that are cut into other companies products.

Great value! Was worried at first but got these and they fit very well. I painted them with bed liner. Easy install as well.

Did not like the instructions, but they were better than most. I had to go to the hardware store to get something to make them actually fit. I only used four of the screws and nuts provided. I think it looks good overall, but would have gone with another selection if I had more knowledge of what I was getting. I don’t want this to be negative. I just am being honest. I have a rear set coming next week and then I’ll be able to see if they’re similar or better.