Trans-Dapt Performance Throttle Body Adapter, 1/4 in Thick, Gasket/Hardware, Steel, TBI Rear Mount to Spread Bore Intake, compatible with Small Block Chevy, Each

The adapter came very quick and was in great condition. It bolted up just like it was supposed to. Would recommend again and again

I did not notice any warpage that others have reported, fit and finish looks good

Product looks good and sturdy. It is fairly thick and pretty heavy, should work well. I will update once I actually install it. I have a throttle body Spacer but as thick as this is I don't think I will use it with this.

Did not fit my Chevy 350. The plate was too narrow and could only get one of the holes to sit on a stud and the other holes did not line up.

Decently made product by t failed to seal properly on my spread bore plenum. Had to get adapter plate to make proper seal below TBI adapter

Good

it fit great just as needed, i used it with a 305 motor that i wanted to run tbi !

Plate did not have the flare in the two back holes, which would not let the bolt set flush with plate. Due to the throttle body would not flush witb plate leaving a gap