VStoy Pro-Line Pro-Stitch Leather Chisel Craft Hole Piercing Punch Tool 2.7mm

I'm very impressed with the quality of these irons, a solid value without a doubt and getting them in three days was a huge plus. At this price point I don't think it's realistic to ask for any more as they seem to be lacking in two minor areas that would likely drive cost way up; a longer/fatter handle and a good polish job on the tines. That would perfect these, but again, I think they are spot-on for the money and I'll be looking at future purchases if additional sizes become available.

2.7mm clearly for small projects, but the teeth themselves are 3mm wide. So these might be useful for ribbon, but not for small thread. 0.06mm thread takes up like 1/3 of the hole after sewing. Looks horrible.

I liked the quality, Wished there was more to the handle when sticking with Maule. Can't complain over all. Like shopping Amazon. Wished that I had more money.🙊🙉🙈

For the price, these are a fantastic deal. You aren't going to find pricking irons this cheap anywhere else, period. That said, the quality is pretty rough. The teeth are straight and regularly spaced, but the interior faces of the teeth are **super** rough. Rough as in, gritty and not even flat, the interior faces have kind of an uneven "wave" or series of small humps on them. Also, they also aren't very sharp. If you use pricking irons a good bit, these will need quite a bit of work to make glide out of the leather smoothly; more than just a polish. I bought these as an easy way to try out this style pricking iron in a moderate SPI (7.5) before committing to an expensive set. I have been very happy with them for that purpose.

I haven't used them yet, but seem to have a mediocre polish on them. I will have to polish them up a bit more to make them glide thru the leather without distortion (normal for these type of tools.) The 3.38mm looks to be correct from start of stitch to start of next stitch. They are a bit on the short side, the dimensions listed in the ad are not even close. Mine are 3.75" long from tip to the striking end. Will they work? yes but seller needs to fix dimensions on ad. 8.2 x 5.5 x 0.4 inches is not correct measurements. Would I still purchase them? Yes, I think so, they look to be good quality steel.

Have only done brief test on item as they are just in my hands. So far very good. They look superbly machined, very well made, and for the price would be very hard to beat.

They work well and are strong.. although leave a wide hole, which given the spacing isnt the greatest since normally using smaller thread for smaller spacing. The surface between the teeth you can see was laser cut but is not cleaned up AT ALL. Be prepared to do a lot hand work on these to polish them up, maybe a little grinding to narrow the tips of the teeth to shorten the hole length.

These pricking irons are a great value for the money. Need a little polishing, but they do a great job laying out stitching holes for my leather projects. I finish the holes with a hand awl. I am going to rig up a round handle to make it easier to hold and align the punches - the flat handles are a little clumsy. Overall a great buy!