Wolfride 4pcs Core Box Router Bit 1/4 Inch Shank Round Nose Cove Box Router Bits

I used one to route a juice grove in a maple cutting board. It cut well with minimal burning in the maple wood. Seem of good quality for the price

I was surprised at how well these work considering the purchase price.

Nice variety of sizes. Good price for carbide tipped bits. Needed for cutting fluted table legs. Welcomed addition to my router bit selection.

They came quickly, I wasn't sure which size was going to work for me so the multi size pac was also good. Ran a few test cuts and for what they were needed for I'm happy with the results

These are sharp and have held up well so far. The center of any bit of this design doesn't cut well so I hog out the center of the cut first (for the larger bits) and just use these for the final cut. They leave a clean smooth edge requiring little sanding.

This is probably my fault but the router bits are 1/4 inch and I strongly prefer 1/2 inch. For you, this might not be a problem. Also, they feel cheap and seem to dull after about 100 or so feet. They might last well. If they do I'll upgrade my review.

Decent value, works well.

I bought this set to cut a juice groove into a cutting board I made and I was very happy with the cutting quality of the bits, even with just a handheld trim router. There was no tear out or burning (maple and walnut) and it made a perfect round cut. If you're looking for a juice groove bit to use with a trim router, I'd buy these. Really happy they each came in their own protective case.