Magigoo Pro PC - The 3D printing adhesive for Polycarbonate

Used this with Rigid Ink's Polycarbonate and also Polymaker PC-Max on the Prusa Mk3 powder coated textured sheet.Worked extremely well for me, 290C on Extruder and 115C Bed when using the Rigid Ink Polycarbonate, reduced Extruder to 270C for the PC-Max.I do use a passive enclosure that really helps too.Top tip: Print yourself some replacement extruder plastics with PC-Max BEFORE attempting 290C , the Standard PETG extruder parts just soften and fail at 290C.

Works very well, keeps your prints secure yet makes them rasy to release without a fight. Great product that washes off your build plate with ease. So win-win in my book! 👍 #3Dprinting #EasyRelease #HappyPrinting

Works well, but massively overpriced and difficult to get a good looking first layer with PC a this lies on the bed as a thick gloop

Works ok but over prised on Amazon by a lot works as well as cheap £1 hair spray in my view there is better and cheapet options out there if you use hair spray remember pre heat your bed and spray wait till the bed is dry repeat 3 or 4 times then print you do not need to apply spray every time only when print starts to move do you reaply

Im using Polymaker Polymax on PEI printbed. It was either not sticking well and warping or sticking too well and damaging printbed when removed. Tried many of the normal ways to get the right amount of adhesion.For me and my setup, so far its working perfectly. 270deg hotend and 110deg bed. Lightly sanded PEI sheet.This stuff releases better when cold if you have the patience to wait.