ABS Plastic Junction Box, Dustproof Weatherproof IP65 Electrical Box - Universal Project Enclosure Pale Pale Grey, with PC Transparent/Clear Cover and Fixed Ear 3.3"x2.3"x1.3"(83x58x33mm)

Well constructed and designed.

The media could not be loaded. I needed something that had a clear face and was waterproof for an outside project. This product appeared to be what I needed. So purchased it and tested it. I tested it by sealing the case and sticking it in my sink underwater for approximately 3 hours. Pulled it out of the water open the case and my little note that I stuck inside was still dry. At this point it determined it was going to be perfect for what I needed it for. The project required stuffing two pieces of electronics that would remain outside for a long duration. A small phone and a solar panel. So far everything is good. If you need a small case that is waterproof this would be the case to get. And it's reasonably priced as well.

With its waterproof seal, that juts into the container, it makes the inside kind of low in volume. If they stated the inside volume, that'd be nice. I have used it for an appropriate project, and it works well to have a clear top (metering with LEDs). So, it's good for the money. Good plastic, solid feel.

When installing solar panels on the motorhome I needed a "combiner box" to connect the wires from multiple strings before heading down through the roof. This has an effective water tight gasket, and effective compressive over-center hasps to keep things dry.

No top-down shots showing that the inside of this box is s-shaped, meaning that the internal dimensions are high misleading if you're trying to fit a rectangular PCB. Make sure you double-check the inside dimensions AND shape!

These are very nice boxes, good fitting components.

This box is very sturdy and easy to install. Would definitely buy again.

Very good quality. In my case, I actually drilled holes to allow power and Ethernet to come in and I can attest it is made of very sturdy plastic. One thing to keep in mind is that the inside is more a "cross shape" than a square as the area where the screws screw in are significant; (about 10mm by 14mm each).