Led Panel Ceiling Light Fixtures 18w 5730 SMD Circle Annular Round Replacement Board Bulb 3500K 1-Pack(Warm White)

I used these to replace the FC12T9 circline 12" round florescent tubes in 2 ceiling fixtures that were rated at 1600 lumens each.These went in very easily and quickly. I chose 3000K (warm white) for our bedroom closet. Since I just installed these today I can't comment on longevity of the LEDs and driver.Here's what I did to install:o Prep the lights by screwing the 5 supplied, small magnetic standoffs to the LED ring and 2 to the LED driver.o Removed all the old CFL hardware from the existing light fixture with a phillips screwdriver.o Making sure the power was off, cut the AC wires going to the CLF ballast as close to the ballast as possible and stripped the ends about 1/4".o Using the magnetic standoffs attached the LED ring and driver to the steel base of the old light fixture.o Using the supplied spring loaded slicing block attached the 2 wires from the LED driver to the AC wires. It doesn't make any difference which AC wire goes to which lead on the AC driver.o Put the light fixture cover back on and beautiful, instant on LED light!

Installed like a dream -- removed circle florescent and ballast, magnets were helpful. Very pleased with light quality. Packaging minimal. Included transformer now cannot start lights -- a little flash and then no light. Disappointing.

Simple and cost effective upgrade to the light in my bathroom. Cheaper than replacing the two round fluorescent tubes! Installed in just a few minutes. Highly recommended.

We got this light to replace an old fluorescent circular bulb and ballast that was making an annoying buzzing noise. It arrived with no instructions, but fortunately it was fairly easy to install (we wired red to black, and blue to white). In fact, we didn't even use the supplied magnets, but instead got it to fit to the metal clasps that were holding the fluorescent bulb. The light is pretty bright, much brighter than our old fluorescent bulb, but it also very white, with almost a little blue-ish tinge. All in all, very happy with the purchase though.

I used this for a torchier replacement. The install was straight forward. The only down-side, is that the 'warm' led light is still very cool.

I had ordered a motion activated overhead LED fixture for our closet a few years ago and the LED board recently died.Physically, this is an exact replacement, but he color is just a little bit off. It has a very slight orangy/pink tinge to it. Not enough to really call a complaint, but it's not the same color as the original "warm white" color.All in all though, it works great.

Light kit was fairly straight forward to install on old fixture. The light was bright but the unit just died after 5 months of normal use.

Was dreading the thought of replacing all the fixtures in the basement. These saved a bunch of work expense, and gnashing of teeth over shopping for light fixtures. Added bonus of a much brighter basement for cheaper than new fluorescent lamps and a ballast or two would have cost!