GolfWorks Ultimate Golf Club Grip Installer Re-Grip Tool

Works for the larger shafts and makes getting the grip on so much easier.

I did not know (and no products gave any clue) that regular grips will not work with TM bubble shafts. I did get one to go finally at the expense of skinning my hands. Then with research, I did come across this product. Very pricey but essential. Tricky to use until you get the hang of it. Next time I will get wider grips that fit the bubble shafts.

It didn't work as easily as I hoped; however, it does help put the grip on the shaft; however, it is cheap lightweight piece of plastic and costs far more than it should. I think I would have been better off 3D printing my own version of this tool but I didn't have time as I needed to regrip some old TaylorMade Bubble Burner 2's before a golf trip as my new clubs didn't arrive in time.

Works for those hard to slip on golf grips

I needed this to regrip my trusty Taylor made railor with a bubble shaft. Makes the install simple for the occasional larger shaft.

Great for what it's used for.

I followed the steps as shown in videos. Used solvent, the pushed the narrow part of the tool into the grip and tried to slide it over the club; NO DICE. Would not slip or budge after the first 2 inches - AT ALL. Tried it with several variations. Nothing. Ended up having to slide 11 grips by pushing them without the tool, using a car tire air pump to help with a few of the real difficult ones.

It really did make the regrouping process so much simpler. I used it to regrip my Taylormade driver which had a bubble shaft with a flare at the end of it. I use the tool and the grip went right on.