Beiter DC Power Razor E100 E125 E150 Electric Scooter Battery 12V 5AH - 2 Pack

Beware you will need to do a little electrical work, as your current batteries are likely hard wired.

These batteries worked great. They were easy to install but the Razor E100 battery compartment is very tight so these have to go in similar to how they came out so make sure you take a picture before you start otherwise you might have to play around with it more than I did. Overall though, this is a very simple install. You'll have to cut the old wires, strip some insulation back on them about a 1/4" - 3/8", and then crimp a connector onto the end of the wire and connect it to the battery but it's really very easy to do. I went to an Auto Parts store and purchased female connectors sized 16-14. Carefully remove the batteries and work on the wires one at a time. Cut the wires close to the original terminals, strip the wire, and then crimp on the connector. Then hook the battery back up and cover the terminals with electrical tape. The connector will stay on by itself but the terminals shouldn't really be left bare. Then do the next battery. The red wire on your scooter goes to the red terminal on the battery and the black wire goes to the black terminal on the battery. Put the batteries back in, close it all up and you're off and running. Yep! My batteries came charged and ready to go once the install was done. Run time is excellent. In fact, it exceeds my expectations. Charge time is even better. My old batteries would take 24 hours to charge and only last about 20 minutes. These batteries charge overnight when fully drained and easily run for MORE than a full hour. If they're only partially drained then they charge up in a couple of hours. Batteries Plus wanted $35 for each battery. These cost me less than $25 shipped and I plan on using these for all of my scooter battery replacements.

These batteries came pre charged and ready to use. Now, When I say ready to use, That doesnt mean stick them in and go. theres alot of negative reviews on here because people thought they could plug them in and just take off. That is not how it works. In my case I was buying them for a razor scooter e100. I knew when I bought these batteries because I looked at the scooter it was not plug and play, If your buying these (Or any) batteries for the razor, they are not going to just plug in. these scooters come from the factory with soldered wires directly to the battery terminal, you must cut these wires, add the appropriate connector to the wire and then you can plug the batteries in, once you do this, all replacement batteries will then be plug and play. It really eats at me when someone provides a product then gets blasted because the consumer didnt do there homework. If you know before hand what you need and what you have to do, these batteries are perfect, in fact, we have two scooters we bought at exactly the same time, one was never right from day one. the other would be going hours after the the other quit. Now, they are almost identical, even in speed, which they never were before. great purchase, Batteries are holding out well and doing a great job! Would purchase again in a heartbeat....

Worked as expected

Good