PWM Fan Hub, PC CPU Cooling 4 PIN/3PIN Power Fan Extension Cable Hub Splitter Adapter Sleeved Case for 12V Desktop Computer Cooler Fans 1 to 5 Way (15.7 Inch)

Very simple yet useful item that enabled me to connect my liquid cooler to my motherboard. I initially had it connected to power via a controller that came with the AIO. However since I am no longer using the controller or the software (Masterplus+) for the AIO, I routed those connections via this adapter. Helped to improve wire management. Glad that I purchased this.

Been a great accessory for PC building. I've used these 3 times and keep extras for future projects. Works great when there's only one fan header or daisy chaining isn't an option. Strong adhesive on sticky pad and small footprint so it can fit almost anywhere in a case.

Easy to install and after several months, still works well to provide power to all my case fans from a single 4-pin motherboard input.

This fan hub does exactly what I needed—lets me add more fans to my PC without any issues. The build quality is solid, and the sleeved cables make everything look clean. Installation was easy, and all my fans are running perfectly.The only downside is that it’s a bit tricky to hide if you don’t want it visible through the glass panel. It would be nice if it had a more compact or low-profile design for easier cable management. Other than that, it’s a great product and does the job well!

Super easy plug and play for fans. Using with four case fans and it works just fine.

works great.

The media could not be loaded. It works as intended and runs great. If you are looking into this as a way to power a pump on an AIO, I HIGHLY suggest you do not buy or use this product for that. That being said, the adapter itself has 5 headers, allowing you to power 5 fans off 1 MB header. I personally would not recommend running more than 3-4 fans off this product, especially if you're new to building PC's. Note that the first header labeled " CPU " must be the first fan position when using this product. After the first 3 headers, the 4th and 5th will supply power, but will not run your fans at full power. If you have an experience like others on in the reviews of the product catching fire or so called " exploding " then you are either running too much power to the product or your MB cannot supply 5 fans on the product. As for the wiring itself, it's very well sleeved and protected. It's length however is rather short so definitely plan ahead on your fan placements and header locations on your motherboard. The sleeve on this product is very difficult to bend and manipulate, I suggest you only bend the cable at areas that are not directly near the header or the actual board itself, it felt fragile. I would recommend this product to anyone intending to add more than 5-10 fans within their build, just make sure to check your MB support.

I previously had a PWN fan hub that required SATA power and the size of it and all the wires drove me crazy. So I replaced it with this, and it fits under my PSU nice and cleanly. It supports up to 5 fans but I use 4, each drawing 0.2 A with this device. I can't even see the fan wires when I look into the case, because this product fits so cleanly and seamlessly into the computer case.